Location:Home > > Industry news >
The central feeding system maintenance knowledge do?
Date:2017-01-11 15:26:27 Hits:2540
The central feeding system (also known as the central injection molding machine feeding, automatic feeding system, central feeding) important components are: central console, fan station (central host), cut the wind cut-off valve, level switch. These components are like the skeleton of the system, and each component is complementary to each other. Level switch level detection signal is transmitted to the central console, the central console by the program start fan, open cut wind cut-off valve, start the suction action. Failure of any component, the system will not operate properly. Of course, the central feeding system in Xin Department of these components in the production of domestic and international famous brands, the quality is guaranteed, the failure probability of course is very small, but as everyone knows, either domestic or imported electrical electronic components will appear fault can not be estimated, only the size of the frequency, and we want to reduce the fault the frequency, ensure the normal operation of the system to carry out regular maintenance on the.
Central console
Regularly check whether or not the PLC terminal loose, if you want to tighten the touch screen, whether there is dust, whether there are sharp items around, if there is a need to clear; after the touch screen operation must be on the protective cover.
Fan station (central host)
Regular gear oil; dust to clean up, especially the pulse dust collector must be cleaned in a timely manner, otherwise, a fan into the interior of the dust will increase, two to reduce the feed pressure.
Air cut-off valve
Regularly adjust the air valve, so that the cylinder has a suitable operating speed. Because the cylinder speed is too fast, it will cause the service life of the silica gel, the speed is too slow to run.
Level switch
Pay attention to the power switch of the material level switch to keep it in a natural state.
The other source must be clean, the central feeding system maintenance knowledge do? Otherwise, gas and water from entering the solenoid valve will cause damage to the spool, influence.
Central console
Regularly check whether or not the PLC terminal loose, if you want to tighten the touch screen, whether there is dust, whether there are sharp items around, if there is a need to clear; after the touch screen operation must be on the protective cover.
Fan station (central host)
Regular gear oil; dust to clean up, especially the pulse dust collector must be cleaned in a timely manner, otherwise, a fan into the interior of the dust will increase, two to reduce the feed pressure.
Air cut-off valve
Regularly adjust the air valve, so that the cylinder has a suitable operating speed. Because the cylinder speed is too fast, it will cause the service life of the silica gel, the speed is too slow to run.
Level switch
Pay attention to the power switch of the material level switch to keep it in a natural state.
The other source must be clean, the central feeding system maintenance knowledge do? Otherwise, gas and water from entering the solenoid valve will cause damage to the spool, influence.
Previous:No Data
